develooper Front page | perl.daily-build.reports | Postings from April 2022

Smoke [blead] v5.35.10-113-g73bc018bb73 PASS linux 5.10.17-v7l+[Raspbian GNU/Linux 10.11] (armv7l/4 cpu) {blead_gcc_quick}

From:
George Greer
Date:
April 16, 2022 22:03
Subject:
Smoke [blead] v5.35.10-113-g73bc018bb73 PASS linux 5.10.17-v7l+[Raspbian GNU/Linux 10.11] (armv7l/4 cpu) {blead_gcc_quick}
Message ID:
202204162203.23GM3deW1919472@vier.local
Smoke logs available at http://m-l.org/~perl/smoke/perl/arm-linux-gnueabihf-thread-multi-64int/blead_gcc_quick/log73bc018bb73b3e06d1251947efc8bab6268fba9f.log.gz

Automated smoke report for branch blead 5.35.11 patch 73bc018bb73b3e06d1251947efc8bab6268fba9f v5.35.10-113-g73bc018bb73
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpu)
    on        linux - 5.10.17-v7l+ [Raspbian GNU/Linux 10.11]
    using     ccache gcc version 8.3.0
    smoketime 1 hour 48 minutes (average 27 minutes 3 seconds)

Summary: PASS

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.35.10-113-g73bc018bb73  Configuration (common) -Dcc="ccache gcc"
----------- ---------------------------------------------------------
O O         
O O         -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging


Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4

MANIFEST did not declare '.mailmap'

Compiler messages(gcc):
scope.c: In function ‘Perl_leave_scope’:
handy.h:97:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
scope.c:901:21: note: ‘a2.any_uv’ was declared here
scope.c:901:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]

Non-Fatal messages(gcc):

-- 
Report by Test::Smoke v1.72 running on perl 5.28.1
(Reporter v0.053 / Smoker v0.046)




nntp.perl.org: Perl Programming lists via nntp and http.
Comments to Ask Bjørn Hansen at ask@perl.org | Group listing | About