Front page | perl.daily-build.reports |
Postings from April 2022
Smoke logs available at http://m-l.org/~perl/smoke/perl/arm-linux-gnueabihf-thread-multi-64int/blead_gcc_quick/log7ebead7d0c53181ea9cd65eff3102063798e60e7.log.gz
Automated smoke report for branch blead 5.35.12 patch 7ebead7d0c53181ea9cd65eff3102063798e60e7 v5.35.11-25-g7ebead7d0c5
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpu)
on linux - 5.10.63-v7l+ [Raspbian GNU/Linux 10.11]
using ccache gcc version 8.3.0
smoketime 1 hour 57 minutes (average 29 minutes 16 seconds)
Summary: PASS
O = OK F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during: - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep
v5.35.11-25-g7ebead7d0c5 Configuration (common) -Dcc="ccache gcc"
----------- ---------------------------------------------------------
O O
O O -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging
Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4
MANIFEST did not declare '.mailmap'
Compiler messages(gcc):
scope.c: In function ‘Perl_leave_scope’:
handy.h:97:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
scope.c:901:21: note: ‘a2.any_uv’ was declared here
scope.c:901:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
Non-Fatal messages(gcc):
--
Report by Test::Smoke v1.72 running on perl 5.28.1
(Reporter v0.053 / Smoker v0.046)