Front page | perl.daily-build.reports |
Postings from May 2022
Smoke logs available at http://m-l.org/~perl/smoke/perl/arm-linux-gnueabihf-thread-multi-64int/blead_gcc_quick/logb08599d9ff94c16f0b4ca323255fbc4971647f4c.log.gz
Automated smoke report for branch blead 5.37.1 patch b08599d9ff94c16f0b4ca323255fbc4971647f4c v5.37.0-87-gb08599d9ff9
develpi.local: ARMv7 Processor rev 3 (v7l) (300 MHz) (armv7l/4 cpu)
on linux - 5.10.63-v7l+ [Raspbian GNU/Linux 10.11]
using ccache gcc version 8.3.0
smoketime 1 hour 52 minutes (average 28 minutes 12 seconds)
Summary: FAIL(F)
O = OK F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during: - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep
v5.37.0-87-gb08599d9ff9 Configuration (common) -Dcc="ccache gcc"
----------- ---------------------------------------------------------
F F
F F -Duseithreads
| +--------- -DDEBUGGING
+----------- no debugging
Testsuite was run only with 'harness' and HARNESS_OPTIONS=j4
Failures: (common-args) -Dcc="ccache gcc"
[default]
[default] -DDEBUGGING
[default] -Duseithreads
[default] -DDEBUGGING -Duseithreads
../t/porting/regen.t........................................FAILED
33
Non-zero exit status: 255
Bad plan. You planned 42 tests but ran 33.
MANIFEST did not declare '.mailmap'
Compiler messages(gcc):
scope.c: In function ‘Perl_leave_scope’:
handy.h:97:35: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
scope.c:1100:21: note: ‘a2.any_uv’ was declared here
scope.c:1100:21: warning: ‘a2.any_uv’ may be used uninitialized in this function [-Wmaybe-uninitialized]
Non-Fatal messages(gcc):
--
Report by Test::Smoke v1.72 running on perl 5.28.1
(Reporter v0.053 / Smoker v0.046)