develooper Front page | perl.daily-build.reports | Postings from February 2023

Smoke [blead] v5.37.9-22-gbe7bcfde51 FAIL(Mmc) linux5.18.18-200.fc36.x86_64 [Fedora Linux 37] (x86_64/1 cpu[8 cores]){blead_clang_sanitize=address}

From:
George Greer
Date:
February 25, 2023 16:21
Subject:
Smoke [blead] v5.37.9-22-gbe7bcfde51 FAIL(Mmc) linux5.18.18-200.fc36.x86_64 [Fedora Linux 37] (x86_64/1 cpu[8 cores]){blead_clang_sanitize=address}
Message ID:
202302251621.31PGLaiU119189@vier.local
Enabled stack-use-after-return (Linux/Darwin) and leak-detection (Linux).  Smoke logs available at http://m-l.org/~perl/smoke/perl/x86_64-linux-thread-multi/blead_clang_sanitize=address/logbe7bcfde514006546f32b6d5b0675685b293d13c.log.gz

Automated smoke report for branch blead 5.37.10 patch be7bcfde514006546f32b6d5b0675685b293d13c v5.37.9-22-gbe7bcfde51
vier.local: Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz (GenuineIntel 3800MHz) (x86_64/1 cpu[8 cores])
    on        linux - 5.18.18-200.fc36.x86_64 [Fedora Linux 37]
    using     ccache clang version Clang 15.0.7 (Fedora 15.0.7-1.fc37)
    smoketime 4 hours 25 minutes (average 17 minutes 40 seconds)

Summary: FAIL(Mmc)

O = OK  F = Failure(s), extended report at the bottom
X = Failure(s) under TEST but not under harness
? = still running or test results not (yet) available
Build failures during:       - = unknown or N/A
c = Configure, m = make, M = make (after miniperl), t = make test-prep

v5.37.9-22-gbe7bcfde51  Configuration (common) -Accflags="-g -fno-omit-frame-pointer -fsanitize=address  -fno-common -fsanitize-blacklist=`pwd`/asan_ignore" -Aldflags="-fsanitize=address" -Dcc="ccache clang"
----------- ---------------------------------------------------------
M - - m - - -Accflags=-DNO_MATHOMS
m - - m - - -Accflags=-DPERL_POISON
M - - M - - -Duse64bitall
M - - m - - -Dusemorebits
c - - c - - -Duseithreads -Accflags=-DNO_MATHOMS
M - - - - - -Duseithreads -Accflags=-DPERL_POISON
m - - m - - -Duseithreads -Duse64bitall
m - - M - - -Duseithreads -Dusemorebits
| | | +----- PERLIO = perlio -DDEBUGGING
| | +------- PERLIO = stdio  -DDEBUGGING
| +--------- PERLIO = perlio
+----------- PERLIO = stdio


Failures: (common-args) -Accflags="-g -fno-omit-frame-pointer -fsanitize=address  -fno-common -fsanitize-blacklist=`pwd`/asan_ignore" -Aldflags="-fsanitize=address" -Dcc="ccache clang"
[stdio] -Duseithreads -Accflags=-DPERL_POISON
    ../cpan/ExtUtils-MakeMaker/t/02-xsdynamic.t.................FAILED
        Non-zero exit status: 28
        No plan found in TAP output
    ../cpan/ExtUtils-MakeMaker/t/03-xsstatic.t..................FAILED
        Non-zero exit status: 28
        No plan found in TAP output
    ../cpan/ExtUtils-MakeMaker/t/INST.t.........................FAILED
        Non-zero exit status: 28
        Bad plan.  You planned 26 tests but ran 2.
    ../cpan/ExtUtils-MakeMaker/t/INSTALL_BASE.t.................FAILED
        Non-zero exit status: 28
        Bad plan.  You planned 37 tests but ran 3.
    ../cpan/ExtUtils-MakeMaker/t/INST_PREFIX.t..................FAILED
        Non-zero exit status: 28
        Bad plan.  You planned 52 tests but ran 2.
    ../cpan/ExtUtils-MakeMaker/t/Mkbootstrap.t..................FAILED
        2-3
        Non-zero exit status: 28
        Bad plan.  You planned 18 tests but ran 6.
    ../cpan/ExtUtils-MakeMaker/t/PL_FILES.t.....................FAILED
        2
        Non-zero exit status: 28
        Bad plan.  You planned 12 tests but ran 2.
    ../cpan/ExtUtils-MakeMaker/t/VERSION_FROM.t.................FAILED
        Non-zero exit status: 28
        Bad plan.  You planned 1 tests but ran 0.
    ../cpan/ExtUtils-MakeMaker/t/WriteEmptyMakefile.t...........FAILED
        Non-zero exit status: 28
        Bad plan.  You planned 5 tests but ran 0.
    ../cpan/ExtUtils-MakeMaker/t/basic.t........................FAILED
        Non-zero exit status: 28

MANIFEST did not declare '.mailmap'
(See log because mailing list size limit is too small.)
Non-Fatal messages(gcc):

-- 
Report by Test::Smoke v1.72 running on perl 5.36.0
(Reporter v0.053 / Smoker v0.046)




nntp.perl.org: Perl Programming lists via nntp and http.
Comments to Ask Bjørn Hansen at ask@perl.org | Group listing | About